DFP (Digital Flat Panel) interface uses an MDR20 (Micro Delta Ribbon) connector, which allows only digital signal transfer. It is restricted to resolutions up to 1280 x 1024.
DVI (Digital Visual Interface) uses a DVI connector, which allows digital or analogue signal transfer. It incorporates a second digital link (Dual Link) which allows resolutions up to 1920 x 1080.
- MDR20 Male to DVI-D (Digital) Female
- For use with modern TFT (Thin Film Transistor)/LCD (Liquid Crystal Display) Flat Panel Displays
- Cables and adaptors are available from LINDY for the three most common video interfaces used today
- EMC (Electromagnetic Compatibility) shielded - Patent pending RF-BLOK shielded design giving:
- Reduced interference from one piece EMI (Electromagnetic Interference)/RFI (Radio Frequency Interference) shield
- Increased insulation resistance up to 25%
- No soldering requirements as interconnect design needs no 360 degree soldering - eliminating the possibility of human error and/or cracking of the solder that causes grounding intermittence and the use of the most hazardous waste material - soldering flux
- Tight fit of internal wires as there is no inner mould
- No requirement of ferrite cores as signal loss and degradation are greatly reduced giving enhanced signal sharpness. Without the ferrite cores the cable is less stressed and more flexible
- Smaller overall dimensions which allows more room behind the host or peripheral
- Increased connector and mating strength - the 4 point reinforcement tabs on the RF-BLOK, attached to the connector, strengthens the pair as one
UK
DE
IT
FR
CH
AT
IE
AU
USA
other
Your